|
JERGENS
WORKHOLDING
ON VERTICAL
MACHINING
CENTERS
The
combination of Jergens Workholding's Twin Vises and Locator
Plates is the most flexible and fastest workholding
system available for your VMC.
Setup
and repeat your setups in just minutes with Jergens' super-fast
quick change jaw system.
Use hard jaws hold stock parts, use machinable jaws
to hold castings, forgings, extrusions and other irregular
shapes.
All
Jergens Twin Vise Systems offer:
- Quick-change
hard jaws or machinable jaws
- Holds
two smaller parts or one large one
-
High-strength
and light-weight
-
Adjustable
center jaw
-
Hardened
& ground steel guideways
-
Chip
flow-through cut-outs
-
Interlocking
or straight base design
-
Fully
sealed leadscrew assembly
-
- NEW:
Now also available with hydraulic
operation!
|
Jergens
Twin Vise
for use without Locator Plate
The
Twin Vise Straight Base version offers
the same features as the standard TV System without
the interlocking base design. This provides maximum
versatility on machining centers without locator
plates. It can be mounted directly onto the table
utilizing the t-slots or can be used with Locator
Plates. Please contact Jergens Workholding Solutions for technical
data.
|
|
